Construction cost calculators by trade.

Compare cost ranges for 1,918 construction services, then adjust your job details.

All flooring bathroom kitchen roofing windows & doors painting & finishes HVAC plumbing electrical concrete & masonry decks & fencing landscaping drywall & insulation pool & spa siding & exterior general

Showing 48 of 58 services in HVAC

Central Air Conditioning

HVAC

Replace or install a central split AC system (outdoor condenser plus indoor coil, about 2-5 tons) on existing ductwork, equipment and labor.

$5,000 - $11,000 per project

Central Heating

HVAC

Replace a forced-air central furnace on existing ducts, priced per sq ft of heated floor area.

$1.50 - $3.50 per sq ft

Clean a Furnace

HVAC

Professional cleaning of one residential furnace (burners, flame sensor, blower compartment, filter) by an HVAC technician.

$100 - $300 each

Clean a Furnace Blower

HVAC

Removing, cleaning and reinstalling the blower wheel (squirrel cage) and housing of one furnace or air handler.

$125 - $300 each

Clean a Heat Pump

HVAC

Professional cleaning and service visit for one ducted heat pump system: indoor and outdoor coils, drain, blower and filter.

$100 - $300 each

Clean Central Heating System

HVAC

Whole-system cleaning of a forced-air central heating system (supply/return ducts plus furnace/blower cleaning), priced per sq ft of conditioned floor area.

$0.20 - $0.50 per sq ft

Clean Heating Coils

HVAC

Professional in-place cleaning of the indoor coil of one furnace/air handler or heat pump system (coil sits on the furnace and carries heat-pump heat).

$100 - $400 each

Clean Heating Ducts

HVAC

Whole-house cleaning of forced-air heating ducts (supply and return runs, registers) for one system.

$270 - $600 each

Clean HVAC System

HVAC

Full HVAC air-path cleaning for one system: ductwork and registers plus blower assembly and indoor coil.

$450 - $1,200 each

Clean Water Boiler

HVAC

Professional cleaning/descaling of a residential hot-water or steam boiler with a basic inspection (not repairs).

$150 - $400 each

Digital Thermostat

HVAC

Replace one wall thermostat with a digital programmable or Wi-Fi unit, unit plus professional install on existing wiring.

$130 - $350 each

Dual Fuel Heat Pump

HVAC

Install a dual-fuel (hybrid) system: air-source heat pump paired with a gas furnace, coil and controls, on existing ductwork.

$9,000 - $16,000 per project

Duct Insulation

HVAC

Wrap/insulate accessible supply and return ducts in an attic, crawlspace or basement of a typical home (fiberglass wrap or duct board, seams taped), materials and labor; duct replacement and sealing extra.

$1,000 - $3,000 per project

Ductless Air Conditioning

HVAC

Install a single-zone ductless mini-split air conditioner (one outdoor unit, one wall head, line set, electrical tie-in).

$2,500 - $5,500 per project

Ductless Heat Pump

HVAC

Install a single-zone ductless mini-split heat pump (heating and cooling) with one indoor head, line set and electrical.

$3,000 - $7,500 per project

Energy Efficient Air Conditioner

HVAC

Replace a central split-system air conditioner with a high-efficiency (about 15-18 SEER / 14.3-17 SEER2) condenser and matched coil on existing ductwork.

$6,500 - $11,000 each

Energy Efficient Furnace

HVAC

Replace a furnace with a high-efficiency (90%+ AFUE) condensing unit including venting changes, on existing ductwork.

$5,000 - $10,000 each

Energy Efficient Heat Pump

HVAC

Supply and install a ducted air-source heat pump system (outdoor unit, matching air handler/coil) replacing existing equipment on existing ducts; geothermal, new ductwork and rebates excluded.

$5,000 - $12,000 per project

Evaporative Air Conditioning

HVAC

Supply and install a roof- or ground-mounted evaporative (swamp) cooler, including water line, electrical hookup and connection to the home.

$1,500 - $3,600 per project

Floor Furnace

HVAC

Remove an old floor furnace and install a new gas or electric floor furnace in the existing floor opening, with venting, gas/electric hookup and permit.

$1,500 - $5,000 each

Forced Air Electric Furnace

HVAC

Replace or install a forced-air electric furnace (10-20 kW) connected to existing ductwork, with electrical connection and disposal of the old unit.

$1,700 - $7,100 each

Forced Air Furnace

HVAC

Supply and install a standard-efficiency forced-air furnace (gas or electric) replacing an existing unit on existing ducts, including haul-away; new ductwork and fuel conversion excluded.

$3,000 - $7,000 per project

Forced Air Gas Furnace

HVAC

Replace a natural-gas forced-air furnace (80-96% AFUE) on existing ductwork, including venting, gas connection, permit and haul-away.

$3,500 - $8,000 each

Forced Air Heating System

HVAC

Install a complete forced-air heating system (furnace plus supply/return ductwork and registers), priced per square foot of conditioned area.

$4 - $9 per sq ft

Furnace Humidifier

HVAC

Install a bypass or flow-through whole-house humidifier on an existing furnace, with water line, drain, humidistat and wiring.

$400 - $1,000 each

Heat Pump System

HVAC

Replace a central ducted air-source heat pump system (outdoor unit, air handler, line set, thermostat) on existing ductwork for a typical home.

$6,000 - $15,000 per project

Heat Pump Water Heater

HVAC

Install one 50-80 gallon hybrid heat pump water heater replacing an existing tank, including condensate drain, connections and haul-away; panel upgrades excluded.

$2,500 - $6,000 each

Heat Recovery Ventilation System

HVAC

Install a ducted whole-house heat recovery ventilator (HRV) with dedicated supply/exhaust ducting and controls in an existing home.

$2,000 - $6,000 per project

High Efficiency Air Conditioner

HVAC

Replace a central split air conditioner with a high-efficiency (about 17-20+ SEER2) condenser and matched coil on existing ductwork.

$7,500 - $14,000 per project

High Efficiency Gas Boiler

HVAC

Replace a residential boiler with a 90-95%+ AFUE condensing gas boiler including PVC venting and near-boiler piping.

$5,000 - $10,000 each

High Efficiency Gas Furnace

HVAC

Replace a gas furnace with a 95-98% AFUE condensing unit including PVC venting, condensate drain and connection to existing ducts.

$4,500 - $9,000 each

High Efficiency Heat Pump

HVAC

Install a high-efficiency or cold-climate variable-speed ducted heat pump system replacing furnace/AC in a typical 1,500-2,500 sq ft home.

$12,000 - $24,000 per project

High Velocity Air Conditioning

HVAC

Retrofit a whole-home high-velocity small-duct central air system (Unico/SpacePak type: air handler, outdoor unit, plenum, small ducts, outlets) in an existing home.

$10,000 - $20,000 per project

Hydronic Heating System

HVAC

Whole-house hydronic heat: new boiler plus baseboard or radiators for a typical 1,500-2,500 sq ft home, installed.

$10,000 - $24,000 per project

Install Air Conditioning

HVAC

Supply and install a central split-system air conditioner (condenser and matching coil) on existing ductwork, including refrigerant lines, pad and haul-away; new ductwork excluded.

$4,500 - $8,500 per project

Install Duct

HVAC

Install new residential HVAC supply/return ductwork (sheet metal or insulated flex) with fittings, per linear foot of run.

$12 - $35 per linear ft

Install Evaporative Cooling

HVAC

Supply and install one whole-house roof- or ground-mounted evaporative (swamp) cooler with water and power hookup.

$1,300 - $3,500 per project

Install Exhaust Duct

HVAC

Supply and install rigid or semi-rigid exhaust duct (bath fan, dryer or range hood) per linear foot of run, including fittings and sealing.

$12 - $35 per linear ft

Install Furnace

HVAC

Supply and install a new furnace (gas or electric) replacing an existing unit on existing ducts; ductwork changes, gas-line runs and high-efficiency upgrades extra.

$3,000 - $7,000 per project

Install Gas Furnace

HVAC

Supply and install a natural-gas furnace (80-95% AFUE) replacing an existing unit on existing ducts, including venting and connection; duct or gas-line extensions extra.

$3,500 - $8,000 per project

Install Heat Pump

HVAC

Supply and install a ducted air-source heat pump (2-4 ton) on existing ductwork including line set, electrical and startup; ductwork, panel upgrades and cold-climate units extra.

$4,500 - $10,000 per project

Install Hydronic Heating System

HVAC

Whole-house hydronic heat: new boiler plus baseboard or radiators for a typical 1,500-2,500 sq ft home, installed.

$10,000 - $24,000 per project

Install Oil Boiler

HVAC

Replace an existing oil-fired hot-water boiler with a new standard-to-high-efficiency oil boiler, including removal, piping/venting reconnection and startup.

$4,500 - $12,000 each

Install Oil Furnace

HVAC

Supply and install an oil-fired furnace replacing an existing unit (standard to mid efficiency), including venting and oil-line connection; oil tank replacement and duct changes extra.

$4,000 - $8,500 per project

Install Room Air Conditioner

HVAC

Install Room Air Conditioner: national installed price range, materials and labor breakdown, and local pricing by ZIP code.

$666 - $1,026 per project

Install Split System Air Conditioner

HVAC

Supply and install a central split-system air conditioner (outdoor condenser and indoor coil, 2-4 ton) replacing an existing system on existing ducts; new ductwork and electrical upgrades extra.

$4,000 - $9,000 per project

Install Thermostat

HVAC

One thermostat supplied and installed (remove old, wire in new, test) on existing HVAC wiring; C-wire or new wiring extra.

$150 - $400 each

Maintain Furnace

HVAC

One furnace maintenance/tune-up visit (inspection, cleaning, safety and CO checks, filter check); parts, repairs and filters extra.

$150 - $350 per project